[<<Previous Entry]
[^^Up^^]
[Next Entry>>]
[Menu]
[About The Guide]
Miracom HST-DS
DipSwitches: 1-2-4-6-7-10 up.
FroDo config-1: ATEQB1C1M1V1&A2&B1&C1&H1&I0&K1&M4&N0|
FroDo config-2: AT&Y1S10=10S11=70S15=72S28=9S9=4S2=64H|
Dial prefix: ATS7=60DT (OR P if Pulse Dialling)
Dial suffix: X2|
Answer: ATS7=26BA|
Lock port: Yes
Max baud: 38400
Reset to connect speed: No
Lower DTR when busy: No
Lower DTR to terminate: Yes
Toggle DTR before dialling: Yes
Delay between sending characters: 2
I use @@@ as an 'escape' character sequence hence the S2=64... this may
confuse people so maybe it would be better to use
FroDo config-2: AT&Y1S10=10S11=70S15=72S28=9S9=4S2=43H|
which is the default... those settings work great with FroDo etc.. inside RA
theres only the one space for modem init :-( so I rely on the modem being
configured with the above in nvram (i dont like to use nvram too much incase it
gets corrupted), and heres what works in ra:
init: atz|athms0=0m1qs7=26b|
onhook: ath1|
answer: ata|
it may not be the best but it works here and usually gives great throughput :-)
The above Courtesy of Stuart Henderson 2:255/13
Valid on 4th February 1991
Copyright John Barton RemoteAccess Support Europe HQ 2:257/168
This page created by ng2html v1.05, the Norton guide to HTML conversion utility.
Written by Dave Pearson